A new heating and cooling system is one of the bigger purchases a homeowner makes, and prices online are all over the place. Here are the same installed ranges we use for our own estimates in Dallas–Fort Worth, with equipment, labor, start-up and haul-away of the old system included.
Typical installed prices in DFW
- Central AC replacement (condenser + coil): $1,900–$3,200 per ton
- Heat pump system: $2,300–$3,600 per ton
- Gas furnace replacement: $3,500–$7,500
- Duct replacement (per supply run): $350–$650 per run
- Whole-home air purifier / filtration: $900–$2,400
What that means for a typical home
Most DFW homes need a 3 to 4 ton system. A 3.5 ton AC with a matched coil runs roughly $6,700–$11,200, and a 3.5 ton heat pump about $8,100–$12,600. Add a gas furnace for a complete system. Replacing 8 failing duct runs lands around $2,800–$5,200.
Want a number for your home? Try the instant estimator, then book a free in-home visit for exact written options.
What pushes the price up or down
- Efficiency. Two-stage and variable-speed equipment costs more up front and less to run, especially through a long Texas summer.
- Where the equipment sits. Attic installs take more labor than a closet or garage.
- What has to change. A new line set, a bigger return, electrical upgrades or duct changes add cost but are often what makes the new system work right.
- Size. Bigger isn't better. An oversized AC short-cycles, leaves the house clammy and wears out sooner. Sizing should come from your home, not the old unit's label.
How to compare quotes
Ask every contractor for the outdoor and indoor model numbers, the efficiency ratings, what's included (coil, line set, pad, thermostat, haul-away), the labor guarantee in writing and how they sized the system. Then you're comparing the same thing.
Frequently asked questions
Why do two HVAC quotes differ so much?
Compare line by line: the exact model numbers and efficiency (SEER2/AFUE), whether the indoor coil is replaced with the outdoor unit, a new line set, the pad, thermostat, permit, haul-away and the workmanship guarantee. A low bid often reuses parts that should be replaced or skips sizing the system for your home.
Is it OK to replace only the outdoor unit?
Usually not. The outdoor unit and indoor coil are designed as a matched pair. Mismatched equipment can lose efficiency, fail sooner and may not carry the full manufacturer warranty.
Do you require a deposit?
Installs take a deposit when the job is scheduled so equipment can be ordered, with the balance due on completion. Everything is in writing before work starts.